The steam oven stopped making steam and simply heated. He descaled the generator, renewed a scaled up level sensor and showed me the water we had been feeding it. Steam is back and the descale reminder behaves again.
What we repair
Work
We are a one-make shop. Everything below is a Thermador appliance, and there is nothing else on the list.
- Steam ovens A small boiler with an oven wrapped around it. Almost everything that goes wrong with one goes wrong at the water end first.
- Column refrigeration Freedom columns hold temperature well until the air around them stops moving. On this coast, that is where it starts.
- Ranges, rangetops and cooktops Gas burners that will not light, induction elements that drop out mid-boil, and the wiring behind both.
- Wall ovens and warming drawers Temperature that drifts, doors that stop sealing, and the self-clean cycle that takes the oven with it.
- Dishwashers Grit on the top rack, standing water in the sump, and a cycle that has quietly stretched from two hours to four.
- Hoods and ventilation Blowers that have lost half their airflow, and the damper at the end of the duct that nobody has looked at.
- Built-in coffee systems The most mechanical appliance in the kitchen and the one with the shortest tolerances. Most faults are in the brew unit, the grinder or the milk path.
Before anything is ordered
What does a Thermador repair cost in Ponte Vedra Beach?
$80 Flat $80 diagnostic covering the visit and the full diagnostic sequence, credited toward the repair once you approve the work.
| What was replaced | Parts and labor |
|---|---|
| Control board or touch panel | $400–$1,060 |
| Oven thermostat or temperature sensor | $170–$560 |
| Bake or broil element | $190–$590 |
Ranges, not quotations: the figure that counts is written down after the diagnosis, and nothing is priced from a description over the telephone. The band that applies depends on which component failed, which is what the diagnostic is for. The rest of the table is on the pricing page.
Nothing on this page goes above $1,060 for the work itself. Anything heavier than that is a repair-or-replace conversation, and it is one we have at the diagnostic.
Owner feedback
What owners said after a visit
4.6 out of 5, across 69 customer reviews. Each one is a single visit, in the words of the person who paid for it.
The cap outside had filled with debris off the oaks and the flap could no longer swing clear of it. He cleared the run from the roof end, freed the damper and rechecked the draw at the grille. The kitchen clears after frying again.
Wine column ran a couple of degrees warm on the upper zone and the bottles nearest the glass were suffering for it. He checked the door gasket, found a stretch that had taken a set and no longer sealed, and fitted a new length.
Asked before we come out
- What does a Thermador built-in repair cost in Ponte Vedra Beach?
- The visit is a flat $80 diagnostic, credited in full against the repair once you approve it. A completed repair falls inside the table on this page: $400–$1,060 where the fault is control board or touch panel, and $1,060 at the heavy end of what is shown. The firm figure is written down after the diagnosis, never quoted from a description over the telephone.
- How long is the work guaranteed?
- 90 days on labor, 365 days on parts, genuine OEM parts only. The cover is on the part we fitted and the labor that fitted it. A different fault appearing later on the same appliance is a new job, and we say which of the two we think it is before anything is charged for.